BOND AND SEAL GREY 300 mL

Universal use

High-elasticity

Long skin formation time

Can be mechanically machined and painted over (following skin formation) without surface activation

Can adhere same and different materials

Silicone free

Nearly odourless

Non-corrosive

Outstanding adhesive strength on a wide range of materials and surfaces

Dampens vibrations and noise

Compensates expansion of different materials

Enables bonding and/or sealing of complicated and very large components

Joint parts can be repositioned

Does not present any health hazard when cured

Door skin adhesive, body moulding kits, bolted fender joints and fenders, front and rear spoilers, welded joints. Seam sealing/joints, (e.g. overlapping chassis seams, container seals, step-by-step welding seams, housing seals, expansion joints, gap seals). Visible joints, (e.g. connection joints). Area adhesion, (e.g. bumper plates, bed plates, corrugated sheet metal and steps of carrier plates, corner and edge protection plates). Seam adhesion/point adhesion, (e.g. sheet metal overlaps, angle profiles, lorry side panels, mounts, frame adhesions, sign and board mounting). Adhesion of automotive accessories, (e.g. spoilers). External tractor/trailer, (e.g. sealing overlapping seams, FRP adhesion, e.g. windscreens and roof sheeting). Internal tractor/trailer, (e.g. sealing of floor group--usually metal/wood, agricultural machines. Visual joints in folds, welded and overlapping seams). Interior bus (e.g. joint sealing of floor group).

The application surface must be clean, dry, dust and grease-free. Hardened material can only be removed mechanically

Do not bring into contact with alkyd-resin paint systems. Not suitable for glass grove sealing in areas in which UV back reflection can occur. Direct exposure to sunlight can lead to slight surface yellowing. Not suitable for PE, PP, PTFE, silicone rubber, expanded polystyrene and softened plastics. Preliminary testing should be done to determine compatibility with paint