1 X 6 SUP-R-STUD
904.2616000
- UNSPSC 31162102
Delivery
0 Review(s)
IN-STORE
(Live stock shown is only for our stores located in Ontario.)
Not stocked in Vaughan, ON.
Not stocked in Mississauga, ON.
Product Details
| Attribute | Value |
|---|---|
| Anchor Diameter | 1 " |
| Anchor Length | 6 " |
| Material | Carbon Steel, zinc plated |
| Nominal Embedment | 4-1/2 " |
| Min. Anchor Spacing | 10 " |
| Min. Edge Distance | 5 " |
| Thread Length | 3-1/2 " |
| EAN | 4052713988126 |
Benefits & Advantage
| Excellent for setting immediately. |
| Required hole diameter equals anchor diameter. |
| Can be loaded immediately. |
| Can be set in a bottomless hole |
| Simple installation. |
| Nut and washer supplied in package. |
| Available in zinc plated carbon steel, 303/304 stainless steel or carbon steel, mechanically galvanized Class 65. |
| ROHS compliant except for Grade 5 |
Instructions
| Drill hole 1/2” to 1” deeper than anchor embedment. Clean hole of debris. |
| With nut threaded past the end of stud, hammer into position. |
| Tighten finger tight plus an additional 3-5 turns with wrench. |
| If anchor spins in hole, force anchor up using screwdriver until clip binds into concrete. |
Notices
Do not use in brick or block. Not advised for use where vibratory loads are high. Oversize holes are detrimental and will reduce performance data from that published.
| APPROVALS/LISTINGS: • G.S.A. Spec FF-S-325C, Group II, Type 4, Class 1 • ICC ESR-3782 C-STL, ZP 1/4” SS • Metro Dade NCA No: 10-0928.01 |
Review(s)
Product not yet rated.
